[Bluetooth Zigbee Emulator CC-Debugger Programmer]
Description:The CC Debugger is a small programmer and debugger for the TI Low Power RF System-on-Chips. It can be used together with IAR Embedded Workbench for 8051 (version 7.51A or later) for debugging and SmartRF Flash Programmer for flash programming. The CC Debugger can also be used for controlling selected devices from SmartRF Studio.Feature:CC-Debugger can be used to program and debug the following 8051-based system-on-chips from Texas Instruments:CC1110, CC1111CC2430, CC2431CC2510, CC2511CC2530, CC2531, CC2533CC2540, CC2541CC2543, CC2544, CC2545It is possible to control the same devices from SmartRF Studio. In addition, CC-Debugger can control the following transceivers from SmartRF Studio:CC1120, CC1121, CC1125, CC1175CC1100, CC1101, CC110L, CC113L, CC115LCC2500, CC2520It can also be used to program the PurePath Wireless devices:CC8520, CC8521CC8530, CC8531The CC Debugger works with IAR EW8051 version 7.51A or later.
[Zigbee Sniffer Bluetooth 4.0 CC2540 CC2531 Programming Connector Board]
[Bluetooth Zigbee CC2531 Sniffer Bare Board]
Specification:1.Size: 4.1*1.6cm2.Board Thickness:1.6mm3.Operating Frequency:2.405-2.485GHz4.Wireless Transmission Speed Rate:250Kbaud5.Power Consumption:<20mA (receiving);<25mA (transmission)Feature:1.Lead Out 8 IO Ports2.Debug Pin3.Matching Firmware To Achieve Analyzer Function
[Bluetooth Zigbee CC2540 Sniffer Bare Board]
Specification:Size:4.1*1.6cmBoard Thickness:1.6mmOperating Frequency:2.405-2.485GHzWireless Transmission Speed Rate:1MbpsPower Cosumption:<20mA (receiving);<25mA (transmission) Feature:Lead Out 8 IO Ports Debug Pin Matching Different Firmware (Sniffer And BTool) To Achieve Bluetooth Adapter And Protocol Analyzer FunctionThe Dongle Can Be Used As Mini Bluetooth 4.0 Development Board Note: If you need the document , contact us :) Use as follow:The Packet Sniffer is installed on the computer and the software can be downloaded from the TI.COM website 1, after the installation is complete open the software, select BLUETOOTH LOW ENERGY, 2, click "start" to enter, insert CC2540 Sniffer USB dongle device, the software will recognize, 3, select, click on the triangle, began to catch the air. At this time we can carry out the agreement analysis.Some customers will use CC2540 to do DONGLE use, this time the device will need to burn CC2540_USBdongle_HostTestRelease_All.hex, open BTOOL after use.